Rust-Oleum - Rust-Oleum LeakSeal Product Demo

Rust-Oleum LeakSeal Introduction

Rust-Oleum LeakSeal Product Features

• View 1

  • Versatile Flexible Rubber Coating:

    Whether you are using it on metal or concrete, gutters or ductwork, LeakSeal provides a rubberized protective utility coating, designed for hundreds of uses and numerous surfaces.

  • Seals Leaks and Cracks Instantly:

    LeakSeal is an easy-to-use product, that goes on heavy, and actively builds to fill gaps, small holes and cracks, making it perfect for every toolbox, work shop, maintenance room and contractor van.

  • A Water-Tight Seal That Lasts:

    LeakSeal provides a water-tight, flexible seal that prevents moisture penetration, rust and corrosion. While LeakSeal creates a water-tight finish, it is not recommended for application on wet surfaces. The moisture will be trapped underneath the coating and could cause corrosion or bubbling of the coating.

  • Top Coat for a Fresh Look:

    With a smooth and flexible finish, LeakSeal offers the opportunity to cover over your sealed area to fit the look of the rest of your item or space. LeakSeal can be top-coated with solvent or water-based paint in typical re-coat times.

  • Stops Rust Formula for Superior Durability:

    Made with the Rust-Oleum Stops Rust formula, LeakSeal offers a tough, protective finish that resists fading, cracking, chipping and peeling.

Rust-Oleum LeakSeal Application

• Specification 1

• Specification 2

  • Remove dirt and debris from area to be coated. Cover and mask off areas to avoid overspray, if necessary.

• Specification 3

  • Shake can vigorously for one minute after mixing ball begins to rattle. Shake often during use. If mixing ball fails to rattle, do not strike can. Contact Rust-Oleum.

• Specification 4

  • A test spray on cardboard is recommended to obtain feel for spray pattern.

• Specification 5

  • Spray surface in short, even strokes. Hold can 8"-18" from surface. It is recommended to apply a light first coat. The second coat can be applied heavier. Quicker build-up can be achieved by moving nozzle closer in to gap.

• Specification 6

  • Initial spray may have some foaming/bubbling on the surface, but will dissipate as coating dries.

• Specification 7

  • For best results, and dependent on gap size, apply at least two coats. Allow to dry 15-30 minutes before coats. Dries to the touch in two hours and cures in 24 hours.

• Specification 8

  • Top-Coating Tip: Based on 70°F (21°C) and 50% relative humidity, can be top-coated with latex-based or oil-based paints after 24 hours. Cooler temperatures or higher humidity may increase dry times.

• Specification 9

  • Clogging Tip: After use, turn can upside down and press spray nozzle until spray is clear to prevent clogging. If valve clogs, twist and pull off spray tip and rinse it in a solvent such as mineral spirits. Do not stick a pin or other objects into the stem.

• Specification 10

  • CLEAN-UP TIP: Wipe tip off before storing. Clean up wet or dry coating with Xylol or mineral spirits. Throw away empty can in trash pick-up. Do not burn or place in home trash compactor.