HyLoft - HyLoft 96’’ x 48’’ Super Pro Ceiling Mounted Shelf IV Complete Product Demo

HyLoft 96’’ x 48’’ Super Pro Ceiling Mounted Shelf IV Complete Instructions

• Introduction HyLoft 96 x 48” Ceiling Storage Unit
  • Adjustable Height From 24” - 44”
  • 115 Cubic Feet Of Storage
  • 600 Pounds Maximum Weight
• Preparation Precautions
  • Avoid Electrical Contact
  • Beware Of Sharp Edges
  • Locate Utilities
  • Clear Debris & Move Cars
  
  Safety First
  • Ladder Safety
  • Power Tool Cords
  • Protective Eyewear
  
  Read Installation Instructions
  • HyLoft Instructions Included
• Tools Needed To Install Tools
  • 7/16” Nut Driver or Wrench
  • 1/2” Wrench
  • Stud finder
  • Drill With 3/16” Bit
  • Tape Measure
  • Pencil
  • Step Ladder
  • Safety Goggles
  • Hammer
• Parts Included Parts
  
  • 4 - 24’’x48’’ Wire Grids
  • 4 - Angle Brackets
  • 4 - Straight Downrods
  • 2 - Left-facing Downrods With Feet
  • 2 - Right-facing Downrods With Feet
  • 2 - 48’’ Support Frames
  • 2 - 96’’ Support Frames
  • 8 - Lag Screws With Hex Head, 1/4’’ x 3’’
  • 44 - Hex Head Bolts, 5/16’’ x 1/2’’
  • 48 - Locking Collar Nuts
  • 4 - Clamps
  • 4 - Hex Head Bolts, 5/16’’ x 1-1/2”
  • 4 - Hex Head Bolts, 1/4’’ x 1/2’’
  • 4 – Locking Collar Nuts, 1/4’’
  • 2 - Diagonal Supports
  • 4 – 4p finish nails
• Installation Identify Location
  
  • Beyond Or Above Open Door
  • Measure Between High Point, Ceiling
  • 25” Required
  • Use multiple units
• Find framing members
  • No more than one unit on any 2 framing members
  • Angle Brackets Parallel To Framing members
  • Refer To Diagram
• Install Angle Bracket
  • Angle Bracket Center Holes
  • 98’’ Center To Center
  • Option A install: use framing members from 24" to 32" apart.
  • Option B install: Use framing members from 48" to 60" apart.
• Mark framing members
  • Mark framing member locations
  • Pencil-mark hole location on ceiling
  • Pre-drill Outside Holes
  • Install Bracket Screws
• Downrod Assembly
  • Connect Downrod Sections
  • Connect Downrods To Angle Brackets
  • Tighten All Nuts
• Support Frame Assembly Downrod-support bars
  
  • Place 48” Support Frames
  • Secure 96” Support Frames, Forming Rectangle
• Wire Grid Assembly Wire Grids
  
  • Lay Wire Grids Over 96’’ Support Frames
  • Adjust For Proper Fit
  • Tighten Support Frames
  • Fasten Grids Together
  • Add Support Brackets
  • Tighten All Connections
  • Distribute Load Evenly