Lumination LED Suspended Luminaires feature a clean and modern design aesthetic.
A clear, narrow band surrounds the edge of the fixture, making the light source appear to "float" within the frame of the luminaire without seeing a visible light source. You've never seen anything like it.
When off, the fixture appears completely transparent & is free of a light source.
Lumination LED Suspended Luminaires can be connected together for long, continuous runs.
Integrated dimming comes standard with our Lumination LED Luminaires. 0-10V & DALI options are available. These fixtures easily integrate into lighting controls, like daylight harvesting.
Lumination LED Luminaires have a long-rated life of 50,000 hours (L85) and is backed by a 5 year warranty. The protective lens help prevent scratches and allows for ease of cleaning.
Intrinsx technology allows Lumination LED Luminaires to effectively direct light where it needs to go. These fixtures provide ambient up-lighting while also directing the light on the surface of your work plane.
Carefully unpack unit from its packaging. Properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to the luminaire.
Attach crossbar to junction box in ceiling with two 8-32 (M4) screws. Repeat on other side.
Connect the black (line) and white (neutral) wires from the luminaire to the matching-colored wires from the driver enclosure. Connect both green wires to the grounding screw. Refer to the EP-DKIT400UV and EP-DKIT400UD LED Driver Installation Instructions for more information.
Fit canopy over stud of crossbar, then screw cable coupler onto stud.
To adjust height and to level a fixture, squeeze the tip of the gripper and pull the suspension cable to the desired height. Clip the cable with cable cutters to finish the appearance.
Optional: For an improved appearance, electrical wire can be tie-wrapped to the suspension wire.
On the 1st luminaire, disconnect the right-side suspension wire and “Y” shape suspension wire. Then on the 2nd luminaire, disassemble the left-side “Y” shape suspension wire (this one will not be used).
Attach a bracket to each end of the “Y” shape suspension wire using washer, spring washer and M8 nuts. Screw torque should be between 15.3±0.8kg f.
Join 1st and 2nd luminaires together by fastening the brackets on the modified “Y” shape suspension wire from Step 9. Fasten brackets using four M8 screws. Screw torque should be between 15.3±0.8kg f.
Input Frequency (Hz)
0-10V & DALI
Cable Suspension System
L85 @ 50,000 hours
LM79, LM80 & ies
12 x 48 x 1.4 inches
approx. 25 lbs.
Environmental Operating Temperature Range
-10 to +25 degrees C
Environmental Humidity (non-condensing)
20 to 80% Non-condensing, dry & damp location rated
Environmental Storage Temperature Range
-40 to +60 degrees C