Wahl makes home haircutting easy as 1 -2 -3.
This Wahl Clipper comes equipped with a “Taper Lever” which can be used in conjunction with or without a guide comb. Use of the taper lever allows you to effect minute but precise adjustments to your desired length of cut. This is especially helpful to achieve a tapered look for necklines, fades or blending between sections.
2 AA batteries required - Batteries not included in Kit.
The cordless personal trimmer, with two interchangeable heads, removes unwanted hair without nicking or pulling.
1 AA battery required - Battery not included in Kit
The Chrome Pro Instruction Book takes you step-by-step to a perfect haircut.
Comb hair and tangles. Attach the largest guide comb to the clipper. Make sure the taper lever is in the up position.
Start at the hairline on side of head and cut up to middle of head.
Note: If cut hair is too long, repeat with next smaller guide comb.
Continue around head, repeating Step 2.
You are now ready to cut the middle portion of the hair.
Select the proper guide comb. Use the comb with the next highest number than in Step 3.
Example: If you used a #6 comb in Step 3, select comb #7.
Continue cutting around the middle portion of head as in Steps 2 and 3.
For cutting top of head, use the comb with the next highest number than in Step 6.
Start at front bang area.
Cut across top of head.
Comb hair on entire head to assess if further cutting is necessary.
Blend out any cut lines. Lines may form where you change comb sizes. Use the same comb used in Step 3 with taper lever in down position.
Using a rocking motion, blend out the middle cut line.
Using the comb used in Step 8, repeat blending the top outline as in Step 10.
Select the guide comb for the desired length hair. Attach to clipper with the taper lever in the up position.
Hold the clipper flat against the neck and slowly move the clipper through the hair as shown.
Use the same procedure from the lower side of the head to the upper side of the head.
Cut the top using a guide comb two sizes (lengths) longer than the comb used on sides. Start at the front and cut slowly to the back as shown.
Cut around the ears.
No attachments needed. Push the taper lever up to the close cut position.
Start with the sideburns then move to the back of the head.
Continue around ear as shown.
Trim neckline as shown.
The ear guide combs have a built in taper ranging from 1/8" to 1/2".
Attach the left ear guide comb to the clipper. Put taper lever in down position.
Hold the clipper at a slight angle just behind the ear at the hairline. Hold top of ear down.
Move the clipper upward and around the ear.
Repeat the same for the right ear with the right ear guide comb.