Lutron - Lutron Lumea C·L Dimmer: The Solution for DIMMABLE CFL/LED bulbs Product Demo

Lutron Lumea C·L Dimmer: The Solution for DIMMABLE CFL/LED bulbs Save Energy

See Flash demo for product images and multimedia.

See Flash demo for product images and multimedia.

See Flash demo for product images and multimedia.

Step 1. Turn power OFF at breaker and remove wallplate
Step 2. Disconnect existing switch
Step 3. Replacing a single pole switch
Connect wires or screw terminals from box to dimmer. Form wires carefully into wallbox and mount Dimmer, but do not install faceplate yet.
Turn Power ON at circuit breaker (or refuse fuse).
Step 4. Adjust the trim wheel
a. Turn dimmer on and move slider down to the bottom.
b. Turn adjustment dial up (clockwise) until lowest light level is achieved and light output is stable for all
bulbs. Note: If dial stops, do not continue to turn.
c. Turn dimmer off, then back on to verify bulbs turn on.
d. If all bulbs do not turn on, turn adjustment dial down (counter-clockwise) slightly and repeat step c.
Step 5. Once bulbs are dimming properly, install faceplate
Please refer to the installation guide included with your dimmer for more detailed instructions on how to install. For Lutron technical support, please call 1.800.523.9466 (24/7).

Specification 1
- Bulbs Approved for Use with this Dimmer
  For a list of compatible bulbs, click on the link below. This list will be updated as Lutron test more bulbs. Please check back regularly for updates.
  Approved Dimmable CFL/LED Bulb List

Specification 2
- Setting the Adjustment Dial
  You may have noticed that your wall-mounted dimmer is equipped with an adjustment dial. Because performance is so varied from bulb to bulb or manufacturer to manufacturer, the adjustment dial will help you set the bottom of the dimming range for your particular bulb.
  Setting the Adjustment Dial

See Flash demo for product images and multimedia.