Britax Child Safety, Inc - ADVOCATE 70 CS Installation Product Demo

Visit Britax Child Safety, Inc

ADVOCATE 70 CS Installation Rear-Facing Installation

1. Getting Started
2. Rear-Facing Use Notice
3. Adjusting the Harness Height
4. Adjusting the Buckle
5. LATCH Installation
6. Vehicle Compatibility Notice
7. Lap/Shoulder Belt Installation
8. Lap Belt Only Installation
9. Versa-Tether Installation
10. Securing Your Child
Rear-Facing Use Notice
All infants must ride rear-facing at least until they have reached 1 year of age and weigh 20 lbs. However, BRITAX recommends that children ride rear-facing to the highest weight or height specified for this child seat.
Children must meet ALL of the following requirements to ride rear-facing in this child seat:
- The child must weigh between 5 - 40 lbs and
- the top of the child’s head must be at least 1 in. below the top of the child seat shell and
- the harness straps must be positioned at or slightly below the child’s shoulders.
If the child cannot be secured within these requirements because the child is too large, review the forward-facing requirements.
If the child does not meet these requirements because they are too small, use of the infant positioning insert or selection of a different child seat (such as an infant car seat) may be required. The infant positioning insert is sold separately and can be found on www.britaxusa.com.
Adjusting the Harness Height
Be sure to check for the proper harness height before you install your child seat in the vehicle. Place the child in the child seat and place the harness straps over the child's shoulders.
Observe where the shoulder harness is positioned on the child. For rear facing, harness straps should be located at or below the top of the child's shoulders.
Adjusting the Buckle
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
LATCH Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Vehicle Compatibility Notice
Vehicle safety belts differ from vehicle to vehicle. Refer to your vehicle's owner's manual for specific information about vehicle safety belts and their use with child seats.
Please refer to your child seat user guide for a list of vehicle belts that are NOT compatible with this child seat.
Lap/Shoulder Belt Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Lap Belt Only Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Versa-Tether Installation
When using the Versa-Tether, first secure the child seat in the vehicle.
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Securing Your Child
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.

ADVOCATE 70 CS Installation Forward-Facing Installation

1. Getting Started
2. Forward-Facing Use Notice
3. Adjusting the Harness Height
4. Adjusting the Buckle
5. LATCH Installation
6. Vehicle Compatibility Notice
7. Lap/Shoulder Belt Installation
8. Lap Belt Only Installation
9. Securing Your Child
Forward-Facing Use Notice
Children must meet ALL of the following requirements to ride forward-facing in this child seat:
- the child must be at least one year of age and
- weigh between 20 - 70 lbs and
- be 49 in. or less in height and
- the harness straps must be fall at or above the their shoulders, parallel to the level ground.
IMPORTANT: When using position 2, it may be necessary to adjust the harness to a higher position than when the seat is in position 1.
If the child cannot be secured within these requirements because they are too large, another type of child seat (such as a combination-booster or booster) may be required. If the child cannot be secured within these requirements because the child is too small, review the rear-facing requirements.
Adjusting the Harness Height
Be sure to check for the proper harness height before you install your child seat in the vehicle. Place the child in the harness straps over the child's shoulders.
Observe where the shoulder harness is positioned on the child. For forward facing, harness straps should be located at or above the top of the child's shoulders.
Adjusting the Buckle
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
LATCH Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Vehicle Compatibility Notice
Vehicle safety belts differ from vehicle to vehicle. Refer to your vehicle's owner's manual for specific information about vehicle safety belts and their use with child seats.
Please refer to your child seat user guide for a list of vehicle belts that are NOT compatible with this child seat.
Lap/Shoulder Belt Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Lap Belt Only Installation
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Securing Your Child
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.

ADVOCATE 70 CS Installation Cover Removal/Reattachment

1. Getting Started
2. Removing the Cover
3. Reattaching the Cover
Removing the Cover
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.
Reattaching the Cover
Your seat may differ from the one being used in this video, however the procedure is the same. For information specific to your product, please refer to your child seat user guide.