This is a great solution for added security in hotels, motels, apartments or dorm rooms. The doorstop sounds a 120dB alarm when pressure is applied. Its anti-skid base prevents slippage.
Door stop alarm can be activated or deactivated with the convenient on/off switch.
Can be used as an alarm or just a door stop.
No wires.
The door stop alarm has a low battery indicator light. If the batteries need to be replaced, the low battery indicator will illuminate. Average battery life for typical usage is up to one year.
The door stop alarm requires one 9V battery.
1. Slide On/Off switch to the ‘OFF’ position to prevent unintentional triggering.
2. Remove screw on the bottom of the door stop and lift off battery compartment cover.
3. Fit a 9V battery according to the diagram, making sure the terminal polarities are correct.
4. Replace cover being careful not to pinch the battery wires and secure screw.
IMPORTANT:
Remove batteries before storing the Alarm for extended periods. Batteries corrode over time and may cause permanent damage to the unit. Depleted batteries should be removed from the unit and disposed of properly.
Insert door wedge at the base of the door as shown in the diagram, with the pointed edge under the door gap. The alarm is properly installed if the metal contact plate is depressed and the alarm sounds when the door is opened. Make sure the non-skid pads on the bottom of the alarm are in firm contact with the floor.