Detect motion inside or outside of your home. LED indicator alerts you to motion. This unit requires a Choice Alert Control Center.
Lets you know motion has been detected.
Not included.
Identify all the parts before proceeding.
The Motion Sensor consists of 2 parts – The Sensor (Transmitter) and the wall mount. Before installing, remove the screw from the battery door on the back of the Sensor. You’ll need to attach the battery leads to a “9V” battery (not included); Take care to note the polarity markings. Replace the battery cover and secure screw. An Alkaline “9V” battery in the Motion Sensor can last up to 9 months.
Before mounting the Motion sensor, you’ll need to assign the Sensor to a zone on the Control Center.
Step 1 – Press and hold the Learn button on the Control Center for three seconds. After the Control Center sounds a long beep, release the Learn button.
Step 2 – Press the Zone button (1, 2, 3 or 4) for the Zone you want to assign to the Motion Sensor. The LED indicator for that Zone will begin to flash.
Step 3 – Release the Zone button.
Note: Zone 4 is for dedicated alerts only. Sensors in this Zone will not trigger an alarm or chime.
Step 4 – Activate the Motion Sensor
- To activate the Motion Sensor, press the Learn button located inside the battery compartment, or if mounted wave your hand in front of the Sensor (the red LED indicator will flash inside lens area in front of the Motion Sensor). The motion sensor will reset 20 seconds after activation.
Use the ball-head mount to mount the Sensor. The minimum height recommended is 5-6 ft from the floor, depending on where you want to mount the Motion Sensor. Once the location is selected, before mounting you should perform a manual test to confirm the Motion Sensor is within range of Control Center. Mount the ball-head joint to the location with screws provided. Once the ball-head joint is mounted to the wall, slide the back of the sensor onto the ball-head joint. The mounting angle can be adjusted.