Loading

In-Sink-Erator - InSinkErator - Garbage Disposal Replacement Product Demo

InSinkErator - Garbage Disposal Replacement Instructions

  • Tools and Materials Needed
    • Slotted Screwdriver
    • Adjustable Pliers
    • Plumber's Putty
    • Electrical Tape
    • Wire Nuts (2)
  • Optional Tools and Materials
    • Phillips Screwdriver
    • Drain Auger
    • 3/8" Electrical Clamp Connector
    • Second 1 1/2" Drain Trap
    • Hammer
    • Hacksaw
    • Water Hose Clamp
    • Pipe Wrench
    • Copper Ground Wire
    • Dishwasher Drain Connectionn Kit
    • Air Gap
    • Drain Tube Extension
    • Electrical On/Off Switch or InSinkErator SinkTop Switch™
    • InSinkErator Power Cord Kit

     

  • Overview
    • Turn off power
    • Remove existing disposer
    • Check condition of mounting hardware
    • Connect drain and install disposer
  • Removing Existing Disposer
    • Turn off power
    • Disconnect drain trap
    • Loosen mounting ring
    • Disconnect electrical connections
  • Removing Mounting Hardware
    • Loosen mounting screws
    • Pry off snap ring
    • Remove mounting assembly
    • Push old sink flange up through sink hole
  • Installing Mounting Bracket
    • Place putty around opening
    • Press flange into place
    • Slide on pieces from under the sink
    • Tighten bracket
  • Mounting Preparation
    • If needed, tap out the dishwasher plug

     

  • Mounting Preparation
    • Lay disposer on its side
    • Make electrical connections
  • Mounting Preparation
    • Mount disposer under sink
    • Connect discharge tube to drain plumbing
    • Connect dishwasher drain to disposer
  • Final Steps
    • Lock disposer into place
    • Test for leaks
    • Turn electrical on and test operation

 

InSinkErator - Garbage Disposal Replacement Where Does Your Food Waste Go?

See Flash demo for product images and multimedia.

 

Easy2 Technologies