In-Sink-Erator - InSinkErator - Installing a Garbage Disposer Product Demo

InSinkErator - Installing a Garbage Disposer Installation

• Tools and Materials Needed
  • Slotted Screwdriver
  • Adjustable Pliers
  • Plumber's Putty
  • Electrical Tape
  • Wire Nuts (2)
• Optional Tools and Materials
  • Phillips Screwdriver
  • Drain Auger
  • 3/8" Electrical Clamp Connector
  • 2nd 1-1/2" Drain Trap
  • Hammer
  • Hacksaw
  • Water Hose Clamp
  • Pipe Wrench
  • Copper Ground Wire
  • Dishwasher Drain Connection Kit
  • Air Gap
  • Drain Tube Extension
  • Electrical On/Off Switch or InSinkErator SinkTop Switch™
  • InSinkErator Power Cord Kit
• Overview
  • Remove existing drain pipe and strainer
  • Install sink mounting bracket
  • Make electrical and dishwasher connections
  • Connect drain & install disposer
• Remove Existing Drain
  • Loosen and remove drain pipe & trap
  • Loosen strainer nut and remove
  • Clean off old putty around drain
• Installing Mounting Bracket
  • Place putty around opening
  • Press flange into place
  • Slide on pieces from under the sink
  • Tighten bracket
• Mounting Preparation
  • If needed, tap out dishwasher plug
• Installing Disposer
  • Lay disposer on its side
  • Make electrical connections

   

• Installation of Disposer
  • Mount disposer under sink
  • Connect discharge tube to drain plumbing
  • Connect dishwasher drain to disposer
• Final Steps
  • Lock the disposer into place
  • Test for leaks
  • Turn electrical on and test operation

InSinkErator - Installing a Garbage Disposer Where Does Your Food Waste Go?