Loading

Barrette - 6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Product Demo

6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Intro

See Flash demo for product images and multimedia.

 

6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Features

  • View 1

    • Woodgrain Appearance:

      Classic woodgrain appearance without the maintenance of real wood.

    • All American Dogear Style:

      1" x 6" All American Dogear style boards.

      Board spacing = 5/16"

 

6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Gallery

See Flash demo for product images and multimedia.

 

6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Instructions

  • 1.) Staking Your Fence Line

    Pre-determine the location of your fence line as illustrated.

    Locate corner, line, and end/gate posts.

    Determine all gate locations.

    To square up corners of the fence line use the 3-4-5 right triangle method (measure 3' and 4' from the corner and the diagonal from those points should be 5').

    [Detailed Printable PDF]

  • 2.) Locating Posts

    Measure the width of the fence panel (X) add the width of your post (Y) (This is the general post hole location).

    After installing vinyl fence section this becomes the final post location.

    It is highly recommended to dig enough holes to install 3-4 sections of fence at a time to ensure proper post hole placement.

    [Detailed Printable PDF]

  • 3.) Standard Post Installation

        a) Dig post hole 12" in diameter 30" deep
        b) Add 6" of gravel for post drainage
        c) Insert post in center of post hole
        d) Level and plumb post
        e) Fill remainder of hole with concrete according to manufacturers instructions
        f) Recheck level and plumb
        Always allow approximately 2" of ground clearance under your panel.

    Post Installation –
    – If frost line exceeds 30"
    (Figure A)
            Dig hole to the appropriate depth.
            Add 6" of gravel for post drainage.
            Add concrete until a depth of 24" remains.
            Follow above instructions from step (c).

    [Detailed Printable PDF]

  • 4.) Rail Bracket Location

    For correct bracket placement, measure down 2" from the top of the post, and make a mark.

    Then, measure from the top of the panel to the top of the first horizontal rail.

    Mark this measurement on the post for the first bracket placement.

    Next measure the distance from the top of the top rail to the top of the next rail.

    This is the measurement for placement of the next bracket.

    Repeat for any additional rails.

    [Detailed Printable PDF]

  • 5.) Installing Fence Panel

    Set panel into the brackets on the first pre-set post (Figure B).

    Place the next post on the opposite end of the panel ensuring posts are against the panel.

    Secure all screws into the center of bracket slots (Figure C).

    Level and plumb post.

    Add concrete according to manufacturers instructions.

    Horizontally level panel.

    Recheck level and plumb post again.

    Continue installing all other panels using above instructions.

    The finished look shows the post cap 2" above the fence panel (Figure D).

    [Detailed Printable PDF]

  • 6.) Create-A-Gate (Optional)

    Create custom vinyl gates up to six feet wide using:

    • Vinyl Fence Panel
    • Create-A-Gate Framing Kit
    • Gate Hardware

    [Detailed Printable PDF]

    [Create-A-Gate Instructions]

 

6-ft x 6-ft Woodgrain Beige Dog-Ear Privacy Vinyl Fence Panel Video Installation

See Flash demo for product images and multimedia.

 

Easy2 Technologies